This production of 20 panels was designed for use as a mounting point for several industrial switches that constitute the control points of a custom machine, including the primary power switch, machine on, machine stop and an emergency safety switch. The switches and status LEDs are screw mounted to the board. The board itself is designed to be screwed to the main panel via fasteners through the corner holes on the mounting panel.
A control panel designed for a heavy duty product with electronic controls. Production run intended to bridge between initial product production and when high-volume component production comes online. The switches and LED panel are designed to be press-fit into the ABS material and the entire component group adhered to the product.
These cornices will be used to round out the exterior redesign of a residential building. After leaving SCALAR, these components will be finish assembled and painted after exterior building installation. Our cutting capabilities have allowed for the building to have one-off architectural detail work at a fraction of the cost of employing conventional fabrication means.